1371-010 Hydraulic Block Cylinder

The 1371-010 is primarily used when workpieces cannot be clamped from above. It is a low-position swinging fixed hydraulic cylinder, single-acting, with spring return, and a maximum operating pressure of 500 bar.

This cylinder is fixed at a low position with a central pivot point for swinging movement, allowing it to provide two-dimensional force. The horizontal component of the output force is approximately 90%, and the downward vertical component is about 30%. The exact force distribution may vary depending on the clamping position.

This product features oil holes for both pipe thread and manifold-mounted. Normally, the oil holes on the manifold-mounted are sealed with internal hex screws and sealing rings. To use it with the manifold-mounted, you should remove the internal hex screws and sealing rings and plug the G1/4 orifice.

This series is in accordance with German standards.

The product includes a dust seal to prevent external oil contamination from entering the cylinder body.

The maximum operating pressure can reach 500 bar.

This product can be manufactured as pipe thread or manifold-mounted, and the inlet hole position on the manifold can be selected as needed.

It can be made as single-acting (with spring return) or double-acting based on requirements.

Most block cylinders have a filter at the inlet hole to effectively filter out large impurities and prevent them from entering the cylinder body, reducing internal wear and extending the product's lifespan. (Some small block cylinders cannot accommodate filters due to their small size.)